T300K online controller

A. 32—256 grade Gray level，Support software Gamma correction。
B. Support the rules and special-shaped handle.
C. 8 ports output，one port can support 512-1024 lamp pixels.
D. Online (also can SD Card) control, offline control Can be multiple controllers used in combination,
the contents of the line control program stored in the SD card.
E. Compatible with single line or double line chips.

PRODUCT INFORMATION

T300K online controller

1. Support chips：

Support chips：	Software code& Controller type	Lamps/(MAX)	NOTE
LPD6803,D705, 1101,6909, 6912	T-300K-6803	8192	32 grade gray level
LPD8806,LPD8809	T-300K-8806	4096/8192
TM1803,TM1804, TM1809,TM1812	T-300K-TM	4096/8192	TM1804&TM1809Divided into high speed and low speed
TM1903，TM1904， TM1909，TM1912	T-300K-TM19	4096/8192
UCS6909，UCS6912， UCS7009，UCS5903	T-300K-UCS32	8192
UCS1903，UCS1909， UCS1912	T-300K-UCS256	4096/8192	Divided into high speed and low speed
UCS3903	T-300K-UCS1024	4096/8192
DMX512	T-300K-DMX	1360/4096	Compatible with standard DMX512
WS2801,WS2803	T-300K-WS	4096/8192
WS2811	T-300K-WS2811	4096/8192	Divided into high s peed and low speed
DS189	T-300K-DS189	4096/8192
TLS3001,TLS3002， TLS3008	T-300K-TLS	4096/8192
P9813	T-300K-P9813	4096/8192
SM16715	T-300K-SM16715	4096/8192	Divided into high speed and low speed
SM16716	T-300K-SM16716	4096/8192
BS0901,BS0902	T-300K-0901	4096/8192
BS0815	T-300K-0815	4096/8192

NOTE：if chip is 256 grade gray level and Singleline IC choose .When programming choice high speed mode

and one interface controls 1024 lamps the play speed can reach 30 frames/s. Double-line IC or single-lineIC with low speed , one interface controls 512 lamps the play speed can reach 30 frames/s.

4.The meaning of flag

TTL signal（245 signal）：

AC IN	Exchange 220V power supply	COM(common port)	GND (ground wire)
POWER	POWER LIGHT	DAT	Signal
STATUS	Status light	CLK	The clock line
SD CARD	SD card slot

NOTE：According to TTL signal output， Ground of the controller must be connected to the lamp ground.

3. wiring diagram

1. The data port of the controller must be connect with the signal output of led lighting

If the led lighting is dmx led lighting , the B output connect with the data port of controller

2. The clock port of the controller must be connector with the clock port of lighting

If the led lighting is dmx led lighting , the A output connect with the clock port of controller

3.The controller is connected by via the built-in switch

4.The IP address of the computer should be set to: 192.168.60.178

5.The GND of controller must be connector with the GND of led lighting